Programming The Mio R-3
15
Mio Modero R-3 Remote
Serial Commands
The Mio R-3 remote supports a few commands that can be uploaded to the device using a terminal
program such as HyperTerminal. These commands are not needed for normal usage or programming of
the remote.
Serial Commands
@BRT
Set Brightness level
This command can be used to customize the brightness of the red LEDs that
backlight the power button if the predefined brightnesses in Setup Mode are
not fine enough.
Syntax:
"'BRIT-<awake brightness level>,<sleep brightness
level>'"
Variables:
brightness level # = a value from 0 - 32.
"'@BRT-#'" (Set LED Awake brightness level)
"'@BRT-#,#'" (Set LED Awake brightness level, sleep brightness level)
Example:
(1) "'@BRT-16'"
Sets the awake brightness level to 50%.
^CFG #
Enable or Disable Debug
Mode
Syntax:
^CFG- <command value>
Variables:
• # = (1 = Debug Mode ON, 0 = Debug Mode OFF).
Example:
^CFG-1
Turn Debug Mode ON
