Programming the Mio R-4
55
Mio Modero R-4
"^" Button Commands (Cont.)
^BMF
(Cont.)
For some of these commands and values, refer to
theRGB Values for all 88 Basic
Colors table on page 35.
• ’%CF<on fill color>’ = Set Fill Color.
• ’%CB<on border color>’ = Set Border Color.
• ’%CT<on text color>’ = Set Text Color.
• ’%SW<1 or 0>’ = Show/hide a button.
• ’%ST<style>’ = Button style.
• ’%EN<1 or 0>’ = Enable/disable a button.
• ’%WW<1 or 0>’ = Word wrap ON/OFF.
• ’%GH<bargraph hi>’ = Set the bargraph upper limit.
• ’%GL<bargraph low>’ = Set the bargraph lower limit.
• ’%GN<bargraph slider name>’ = Set the bargraph slider name/Joystick cursor name.
• ’%GC<bargraph slider color>’ = Set the bargraph slider color/Joystick cursor color.
• ’%GI<bargraph invert>’ = Set the bargraph invert/noninvert or joystick coordinate
(0,1,2,3).
^GIV
section on page 59 more information.
• ’%GU<bargraph ramp up>’ = Set the bargraph ramp up time in intervals of 1/10 second.
• ’%GD<bargraph ramp down>’ = Set the bargraph ramp down time in 1/10 second.
• ’%GG<bargraph drag increment> = Set the bargraph drag increment. Refer to the ^GDI
command on page 59 for more information.
• ’%OT<feedback type>’ = Set the Feedback (Output) Type to one of the following:
None, Channel,Invert, ON (Always ON), Momentary, or Blink.
• ’%SM’ = Submit a text for text area button.
• ’%SF<1 or 0>’ = Set the focus for text area button.
• ’%OP<0-255>’ = Set the button opacity to either Invisible (value=0) or Opaque
(value=255).
• ’%OP#<00-FF>’ = Set the button opacity to either Invisible (value=00) or Opaque
(value=FF).
• ’%UN<Unicode text>’ = Set the Unicode text. See the
^UNI
section on page 64 for the
text format.
• ’%EF<text effect name>’ = Set the text effect.
• ’%EC<text effect color>’ = Set the text effect color.
• ’%ML<max length>’ = Set the maximum length of a text area.
• ’%MK<input mask>’ = Set the input mask of a text area.
Example:
SEND_COMMAND Device,"'^BMF-500,1,%B10%CFRed%CB Blue
%CTBlack%Ptest.png'"
Sets the button OFF state as well as the Border, Fill Color, Border Color, Text Color, and
Bitmap.
^BMI
Set the button
mask image
Mask image is used to crop a borderless button to a non-square shape. This is typically
used with a bitmap.
Syntax:
"'^BMI-<vt addr range>,<button states range>,<mask image>'"
Variable:
• variable text address range = 1 - 4000.
• button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
1 = Off state and 2 = On state).
• mask image = Graphic file used.
Example:
SEND_COMMAND Device,"'^BMI-530,1&2,newMac.png'"
Sets the button with variable text 530 ON/OFF state mask image to 'newmac.png'.
