Programming the Mio R-4
59
Mio Modero R-4
"^" Button Commands (Cont.)
^FON
Set a font to a
specific Font ID
value for those
buttons with a
defined address
range
Set a font to a specific Font ID value for those buttons with a defined address range. Font
ID numbers are generated by the TPDesign4 programmers report.
Syntax:
"'^FON-<vt addr range>,<button states range>,<font value>'"
Variable:
• variable text address range = 1 - 4000.
• button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons
1 = Off state and 2 = On state).
• font value = range = 1 - XXX. Refer to theFixed Fonts and ID Numbers table on page 37.
Example:
SEND_COMMAND Device,"'^FON-500.504&510.515,1&2,4'"
Sets the font size to font ID #4 for the On and Off states of buttons with the variable text
range of 500-504 & 510-515.
Note:
The Font ID is generated by TPD4 and is located in TPD4 through the Main menu.
Panel > Generate Programmer's Report >Text Only Format >Readme.txt
.
^GDI
Change the
bargraph drag
increment
Change the bargraph drag increment.
Syntax:
"'^GDI-<vt addr range>,<bargraph drag increment>'"
Variable:
• variable text address range = 1 - 4000.
• bargraph drag increment = The default drag increment is 256.
Example:
SEND_COMMAND Device,"'^GDI-7,128'"
Sets the bargraph with variable text 7 to a drag increment of 128.
^GIV
Invert the
joystick axis to
move the origin to
another corner
Invert the joystick axis to move the origin to another corner. Parameters 1,2, and 3 will
cause a bargraph or slider to be inverted regardless of orientation. Their effect will be as
described for joysticks.
Syntax:
"'^GIV-<vt addr range>,<joystick axis to invert>'"
Variable:
• variable text address range = 1 - 4000.
• joystick axis to invert = 0 - 3.
For a bargraph 1 = Invert , 0 = Non Invert
Example:
SEND_COMMAND Device,"'^GIV-500,3'"
Inverts the joystick axis origin to the bottom right corner.
^GLH
Change the
bargraph upper
limit
Change the bargraph upper limit.
Syntax:
"'^GLH-<vt addr range>,<bargraph hi>'"
Variable:
• variable text address range = 1 - 4000.
• bargraph limit range = 1 - 65535 (
bargraph upper limit range
).
Example:
SEND_COMMAND Device,"'^GLH-500,1000'"
Changes the bargraph upper limit to 1000.
0
2
3
1
1 = Invert horizontal axis
2 = Invert vertical axis
3 = Invert both axis locations
0 = Normal
