Programming
72
Modero G4 Touch Panels - Configuration and Programming
"^" Button Commands (Cont.)
^BRD
Set the border of a button state/states.
Only
if the specified border is not the same as the current
border. The border names are available through the TPDesign4 border-name drop-down list. Refer to
theTPDesign Border Styles by Name table on page 62.
Syntax:
"'^BRD-<vt addr range>,<button states range>,<border name>'"
Variables:
variable text address range = 1 - 4000.
button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons, 1 = Off
state and 2 = On state).
border name = Refer to the Border Styles and Programming Numbers table on page 62.
Example:
SEND_COMMAND Panel,"'^BRD-500.504&510.515,1&2,Quad Line'"
Sets the border by name (Quad Line) to those buttons with the variable text range of 500-504 &
510-515.
^BSF
Set the focus to the text area.
Note: Select one button at a time (single variable text address). Do not assign a variable text address
range to set focus to multiple buttons. Only one variable text address can be in focus at a time.
Syntax:
"'^BSF-<vt addr range>,<selection value>'"
Variables:
variable text address range = 1 - 4000.
selection value = Unselect = 0 and select = 1.
Example:
SEND_COMMAND Panel,"'^BSF-500,1'"
Sets the focus to the text area of the button.
^BSM
Submit text for text area buttons. This command causes the text areas to send their text as strings to
the NetLinx Master.
Syntax:
"'^BSM-<vt addr range>'"
Variable:
variable text address range = 1 - 4000.
Example:
SEND_COMMAND Panel,"'^BSM-500'"
Submits the text of the text area button.
^BSO
Set the sound played when a button is pressed. If the sound name is blank, the sound is then
cleared. If the sound name is not matched, the button sound is not changed.
Syntax:
"'^BSO-<vt addr range>,<button states range>,<sound name>'"
Variables:
variable text address range = 1 - 4000.
button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons, 1 = Off
state and 2 = On state).
sound name = (
blank
- sound cleared,
not matched
- button sound not changed).
Example:
SEND_COMMAND Panel,"'^BSO-500,1&2,music.wav'"
Assigns the sound 'music.wav' to the button Off/On states.
