Displaying Stream Content
171
VG-Series Modero Touch Panels
Determine what is the available data rate for the network on which the encoder currently
resides. This information will determine what encoder profile can be used on the outgoing
media content. If the network can only handle a throughput of 4 Mbps from the encoder, it is
recommended that you use something less than or equal to the
High Quality
encoder profile.
Setting up a Modero Panel to Receive and Display a Stream
The MAX-CSE must first be prepared to stream to the target Modero panel prior to creating the
necessary TPDesign4 panel pages (later be uploaded to the panel).
Step 1: Obtaining the IP Address of the target panel
1.
Press the grey Front Setup Access button for
3 seconds
to open the Setup page (FIG. 127).
2.
Press the
Protected Setup
button (located on the lower-left of the panel page) to open the Protected
Setup page and display an on-screen keypad.
3.
Enter
1988
into the Keypad’s password field and press
Done
when finished.
4.
Press the
System Settings
button (located on the Protected Setup page) to open the System Settings
page and obtain the IP information from the
IP Address
field (FIG. 128).
FIG. 127
Setup page
FIG. 128
System Settings page
Connection Status
Red
Connection Status icon -
Green
Connection Status icon -
indicates no connection to a Master
indicates communication to a Master
Modero
IP Address
information
Summary of Contents for Modero NXT-1500VG
