Installation Procedures: 17" Panels
75
VG-Series Modero Touch Panels
Refer to your particular VESA mount manufacturer’s installation procedures for further surface
mounting procedures.
Pre-wall Installation of the CB-TP17 Conduit Box
Wall Mount panels (NXDs) are contained within a metallic outer housing (back box). This back box is
not removed
when installing the NXD into a Conduit Box (CB-TP17). The back box is
only
removed to
gain access for the replacement of the Compact Flash component or upgrade to the VESA housing.
The CB-TP17 Conduit/wallbox is an optional metallic box that is secured onto a beam in a
pre-wall
setting (
where no walls or present
). Installation procedures and configurations can vary. This section
describes the installation procedures for the most common installation scenario.
The most important thing to remember when mounting this conduit box is that the mounting tabs must
be mounted flush against the outside of the sheetrock. This step determines whether or not the mounting
stud is notched (
cutout-out to fit the conduit box
).
1.
Measure the distance between the inside of the two selected stud beams. Most beams have a
distance of about 14" to 16". This is too narrow to accommodate the 17.072" (43.36 cm) wide
CB-TP17 conduit box.
2.
Determine whether one or both of the selected stud beams must be notched (FIG. 55). The
determining factor is the flush alignment of the mounting tabs along the outside of the
post-wall
sheetrock.
FIG. 54
Installation of grommet into the rear plastic enclosure
Rear plastic cover (rear view)
Rim of the strain relief grommet
should lie flush against enclosure
CLIP FACING UP
VESA mount connection location
(USE ONLY AMX PROVIDED #8-32 screws)
INSTALLER: LEAVE A GAP BETWEEN THE STUD AND CONDUIT BOX TO
ACCOMMODATE THE DRYWALL/SHEETROCK.
This gap allows the installation of
the drywall/sheetrock after the CB-TP17 has been mounted onto the beams.
The stud notching and conduit box installation must be done prior to any wall
installation.
Summary of Contents for Modero NXT-1500VG
