Appendix B: Wireless Technology
171
MVP-5100/5150 5.2" Modero Viewpoint Touch Panels
A certificate may be sent to ONLY ONE directly connected panel via USB.
Use the Ethernet port’s IP Address to send a server certificate to multiple panel targets.
8.
S
elect the IP Address which corresponds to the local computer's Ethernet address.
9.
Navigate to the
Add IP Address
field (bottom-right of the interface) and enter the IP Addresses of the
various target touch panels.
10.
Click the
Add
button to complete the entry and add the new IP Address to the listing of available device
IP Addresses. Repeat this process for all subsequent device IP Addresses.
11.
Once the list is complete, click on the
File
drop-down menu and select the
Save
option. This launches a
Save
dialog to assign a name to the current list of addresses and then save the information as a TXT (text)
file to a known location.
12.
Select the target devices to be uploaded with the selected certificate. These may be:
individually selected by toggling the box next to the
Send
entry (with the Type column).
selected as a group by clicking on the
Check All
radio box located at the top of the device IP
Address listing.
13.
When ready to send the certificate file to the selected panels, click the
Send
button to initiate the upload.
Once the
Status
field for each entry reads
Done
, the upload was successfully completed.
The AMX Certificate Upload Utility is intended to be used for only one certificate at a time on the touch panel,
and has no indicator that a certification has been loaded onto a touch panel. After a certification has been
loaded onto a panel using the Certificate Upload Utility, you should immediately enter the certificate name
(including file extension) into the
Client Certificate
field for the specified SSID. (For more information on the
Client Certificate
field in the
Enterprise Mode
popup window, please refer to the
Security Modes
section on
page 62.) Make sure to double-check that the Security Type is correct.
Erasing All Certificates From the Touch Panel
Individual certificates may not be removed from the touch panel. However, all certificates may be removed
from the device by using the
erase cert
telnet command, Certificates may then be re-uploaded, using the AMX
Certificate Upload Utility as needed.
This application must be run from a local machine and should not be used from a
remote network location.
Summary of Contents for Modero ViewPoint MVP-5100
