Programming
114
MVP-5200i Modero® ViewPoint® Touch Panel with Intercom - Instruction Manual
Input Commands
These Send Commands are case insensitive.
Panel Runtime Operation Commands (Cont.)
@VKB
Popup the virtual keyboard.
Syntax:
"'@VKB'"
Example:
SEND COMMAND Panel,"'@VKB'"
Pops-up the virtual keyboard.
WAKE
Force the panel out of screen saver mode.
Syntax:
"'WAKE'"
Example:
SEND COMMAND Panel,"'WAKE'"
Forces the panel out of the screen saver mode.
Input Commands
^CAL
Put panel in calibration mode.
Syntax:
"'^CAL'"
Example:
SEND COMMAND Panel,"'^CAL'"
Puts the panel in calibration mode.
^KPS
Set the keyboard passthru.
Syntax:
"'^KPS-<pass data>'"
Variable:
pass data
:
<blank/empty> = Disables the keyboard.
0 = Pass data to G4 application (default). This can be used with VPC or text areas.
1 - 4 = Not used.
5 = Sends out data to the Master.
Example:
SEND COMMAND Panel,"'^KPS-5'"
Sets the keyboard passthru to the Master. Option 5 sends keystrokes directly to the Master via the Send Output String
mechanism. This process sends a virtual keystroke command (^VKS) to the Master.
Example 2:
SEND COMMAND Panel,"'^KPS-0'"
Disables the keyboard passthru to the Master.
Note: The parameters within this command accept keystrokes from any of these sources: attached USB keyboard or Virtual
keyboard.
^VKS
Send one or more virtual key strokes to the G4 application. Key presses and key releases are not distinguished except in the
case of CTRL, ALT, and SHIFT.
Refer to theEmbedded Codes table on page 115
that defines special characters which can be included with the string but may
not be represented by the ASCII character set.
Syntax:
"'^VKS-<string>'"
Variable:
string = Only 1 string per command/only one stroke per command.
Example:
SEND COMMAND Panel,"'^VKS-'8"
Sends out the keystroke 'backspace' to the G4 application.
