Battery Life and Replacement
127
MVP-5200i Modero® ViewPoint® Touch Panel with Intercom - Instruction Manual
Remove the Old Battery
Peel the hinge cover film from the hinges on either side of the battery before removing the battery. If the battery is attached
to the interior of the device with adhesive tape, carefully pry the battery free.
DO NOT use sharp or edged objects to pry the battery free, as these may damage the battery or the device. Please dispose of
the battery in a proper fashion as required by municipal or federal regulations.
If the battery comes in a protective metal case, remove the two screws holding the battery case to the back cover. Carefully
remove the battery from the back cover. Please dispose of the battery in a proper fashion as required by municipal or
federal regulations.
Install the New Battery
Open the plastic bag containing the MVP-BP-5X kit, taking care not to use sharp instruments near the battery itself.
Attach the new battery to the back cover, either using the two screws used to hold the previous battery to the cover or with
the two replacement screws included with the MVP-BP-5X kit.
Reconnecting the Battery To The Device
1.
On the back cover, make sure that the battery connector wiring runs to the right and that the protective film on the battery
case has been removed. Make sure that the excess battery wiring fits in the space to the bottom left of the battery placement
(FIG. 85). The battery wiring may be looped around the support if necessary; make sure that the battery is not crimped or
damaged upon closure of the case.
2.
Make sure to seat fully the battery plug to the connector in the device (FIG. 84). If fingers cannot be used, use a clean,
nonconductive stick or probe to seat the connectors.
3.
Reattach the back of the device, engaging the hook on the lower left of the case (near the speaker) and using it to swing the
back down into place.
NOTE:
When reassembling the device, take especial care not to pinch, puncture, or damage the battery. Do not force the rear
plate onto the device, as this can damage the device.
4.
Insert the five screws and replace the rubber feet atop the two upper screws, using the replacement rubber feet and bottom
label included in the Battery Pack Kit (FIG. 5).
FIG. 84
Battery installation and connection diagram
FIG. 85
Path of excess battery wiring
Battery Connector
MVP-BP-52 battery placement
Excess battery wiring path
