3
MVP-5200i Modero® ViewPoint® Touch Panel with Intercom - Instruction Manual
ESD WARNING
WARNING
: This product is intended to be operated ONLY from the voltages listed on the back panel or the recommended, or
included, power supply of the product. Operation from other voltages other than those indicated may cause irreversible
damage to the product and void the products warranty. The use of AC Plug Adapters is cautioned because it can allow the
product to be plugged into voltages in which the product was not designed to operate. If the product is equipped with a
detachable power cord, use only the type provided with your product or by your local distributor and/or retailer. If you are
unsure of the correct operational voltage, please contact your local distributor and/or retailer.
BATTERY INFORMATION:
THIS PRODUCT CONTAINS A LITHIUM ION POLYMER BATTERY. IF MISUSED OR ABUSED THIS CAN RESULT IN:
•Smoke or gas hazard
•Heat hazard
•Fire hazard
•
Explosion hazard
WARNING
: If battery compartment does not close securely, stop using the product and keep it away from children and pets
WARNING
: Do not handle leaking or damaged Lithium batteries.
WARNING
: Risk of leakage. Only use the specified type of batteries. Never mix new and used batteries.
Observe correct polarity. Remove batteries from products that are not in use for extended periods of time. Store batteries in a
dry place.
WARNING
: Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the
like.
WARNING
: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
Dispose of used batteries according to the instructions.
WARNING
: Do not recharge non-rechargeable batteries.
WARNING
: OPERATING TEMP 0°C (32°F) to 40°C (104°F). Avoid exposure to extreme heat or cold.
Please dispose of any used batteries properly, following any local regulations. Do not incinerate.
To avoid ESD (Electrostatic Discharge) damage to sensitive components, make sure you are properly grounded before
touching any internal materials.
When working with any equipment manufactured with electronic devices, proper ESD grounding procedures must be
followed to make sure people, products, and tools are as free of static charges as possible. Grounding straps, conductive
smocks, and conductive work mats are specifically designed for this purpose.
Anyone performing field maintenance on AMX equipment should use an appropriate ESD field service kit complete with at
least a dissipative work mat with a ground cord and a UL listed adjustable wrist strap with another ground cord
WARNING
: Do Not Open! Risk of Electrical Shock. Voltages in this equipment are
hazardous to life. No user-serviceable parts inside. Refer all servicing to qualified
service personnel.
Place the equipment near a main power supply outlet and make sure that you can easily
access the power breaker switch.
WARNING
: Do not place batteries in mouth or ingest. Chemical burn hazard. Keep new and used batteries out of reach of
children and pets. If swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
