Configuring Communication
33
MVP-5200i Modero® ViewPoint® Touch Panel with Intercom - Instruction Manual
Automatically Setting SSID
In the
Protected
Setup
page:
1.
Select
Wireless Settings
.
2.
Press the
Site Survey
button at the bottom of the page to open the
Wireless Site Survey
page (FIG. 26).
3.
Select a
WEP
secured AP from within the
Site Surve
y page, and press the
Connect
button. .
4.
If the security is not handled automatically, the information must be entered manually from the
Wireless Security
popup page.
Manually Setting SSID
In the
Protected
Setup
page:
1.
Select
Wireless Settings
.
2.
Click on the
Simple
button to open the
Wireless Security: Simple Mode
popup window (FIG. 27).
3.
Press the
Security Type
field to select
WEP
.
4.
Press the
SSID
field. From the
Network Name (SSID)
keyboard, enter the SSID name used by the target Access Point (
case
sensitive
), and press
Done
when finished.
The card should be given the SSID used by the target AP. If this field is left blank, the device will attempt to connect to the
first available AP.
One of the most common problems associated with connection to a AP arises because of an improperly entered SSID. The
same case must be maintained when entering this information.
ABC is not the same as Abc
.
The alpha-numeric string is
AMX
by default, but can later be changed to any 32-character entry.
This string must be
duplicated within the Network Name (SSID) field on the AP.
As an example, if the SSID is
TECHPUBS
,
this word and the case
within must match both the
Network Name (SSID)
field on the touch panel’s
Network Name SSID
field and on the AP’s
Basic
Wireless Configuration
page.
5.
Toggle the
Encryption
button (FIG. 27) until it reads either
64 Bit Key Size
or
128 Bit Key Size
.
The 64/128 selection reflects the bit-level of encryption security. This WEP encryption level must match the encryption level
being used on the AP.
FIG. 26
Site Survey of available APs (Secured AP shown selected)
FIG. 27
Wireless Security: Simple Mode popup window
Connecting to the AP begins the communication
Select a target AP with the desired level of security
Encryption Button
