Setup Pages
50
MVP-5200i Modero® ViewPoint® Touch Panel with Intercom - Instruction Manual
Power Management Page
The options on the
Power Management
page allow setting of power warning preferences and battery status information, and
adjustment of the display times for battery warnings (FIG. 54).
Features on this page include:
FIG. 54
Power Management page
Power Management Page
Back:
Saves all changes and returns to the previous page.
WiFi/Wired/USB Icon:
The icon to the left of the Connection Status Icon displays whether the current connection to the Master is
Wireless
(image of a radio antenna),
Wired
(image of three networked computers), or
USB
(USB connection
symbol).
Connection Status icon: The icon in the upper-right corner of each Setup page provides a constant visual indication of current
connection status.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx Master.
Power Settings:
The three settings in the
Power Settings
section may be selected by touching either the arrow to the left of each
setting or by touching the entry itself. Each is highlighted with a green arrow to the left when selected.
Sleep:
This value determines the number of seconds or minutes that need to pass before the panel automatically goes
into Sleep Mode. Once asleep, the device may be awakened by touching the buttons on either side of the screen
or the screen itself. Use the
Up/Down
arrows to change the settings; the setting bar will change from blue to
green to display the percentage of minimum versus maximum.
Range = 10, 15, 20, 25, 30 seconds; 5, 15, 30 minutes; 1, 2 hours Default = 2 hours
Stand By:
This value determines the number of seconds or minutes that need to pass before the panel automatically goes
into Standby Mode. Once in standby, the device may be awakened by touching the screen. Use the
Up/Down
arrows to change the settings; the setting bar will change from blue to yellow to display the percentage of
minimum versus maximum. A value of Off disables this feature.
Range = 15, 30 minutes; 1, 2, 3, 4 hours Default = Off
Shutdown:
This value determines the number of hours or minutes that need to pass before the panel automatically shuts
down. Once shut down, the device will have to be restarted. The
Up/Down
buttons alter the timeout value (in
minutes). Use the
Up/Down
arrows to change the settings. A value of Off disables this feature.
Note: Shutdown mode turns the unit completely off, including communication circuits, and preserves battery life,
unlike Sleep mode, which only turn off the display. From Shutdown mode, a unit may be turned on by touching the
screen.
Range = 3, 5, 10, 15, 30 minutes; 1, 2, 3, 4 hours Default = Off.
Disable on External
Power:
This button acts as a power save feature with two options:
• On - Clicking on this button causes the Sleep mode to become disabled when external power is applied.
• Off - Clicking on this button deactivates this power save feature.
Auto Dim:
When enabled, Auto Dim will engage at half the time set under the
Sleep
setting or after five minutes, whichever
is sooner.
Battery Charge Status:
The Battery Charge Status field indicates the power charge currently available on the battery.
Battery Level Port:
The
Battery Level Port
field indicates the port being used to report charge status levels back to the NetLinx
Master (set in TPDesign4).
Battery Level:
The
Battery Level
field indicates the level being used to report status levels back to the NetLinx Master (set in
TPDesign4).
Battery Type:
The
Battery Type
field indicates the type of battery currently installed in the MVP-5200i. The value listed is
XPX5000B
,
2
, or
3
.
