Installing Wall-Mount (MXD) Panels
53
Modero X® Series G4 Touch Panels Instruction Manual
Not all of the tabs must be extended to lock the Backbox in place, but extending a minimum of the top and
bottom tabs is highly recommended.
Apply enough pressure to the screw head to keep the box flush with the wall: this ensures that the locking tabs
will tighten up against the inside of the wall.
The Backbox is clear to allow visual confirmation that the tabs have been extended and are gripping the wall,
as well as in assisting with removal if necessary.
For additional strength, #4 mounting screws (not included) may be secured through circular holes located at
the left and right sides of the MXD-2000XL-PAN (see FIG. 31). In order to prevent damage to the touch
panel, make sure that these are flush with the Backbox.
7.
Insert each connector into its corresponding location along the back of the device (FIG. 32).
8.
Test the incoming wiring by attaching the panel connections to their terminal locations and applying power. Verify
that the panel is receiving power and functioning properly to prevent repetition of the installation.
9.
Insert the four temporary mounting posts of the panel into the openings on the Backbox and slide the panel onto the
Backbox (FIG. 33). This will temporarily hold the panel during the rest of the installation.
Note that FIG. 33 shows the MXD-1900L-PAN, but the illustration applies equally to the MXD-2000XL-PAN.
Also note that FIG. 33 shows a landscape panel but the installation of a portrait panel is essentially the same, other
than the vertical orientation.
FIG. 32
MXD-2000XL-PAN / MXD-1900L-PAN - rear connectors
Ethernet 10/100 Port
Type A USB Port
12 VDC Power Port
(limited access)
Refer to the Power via 12 VDC
section on page 54
for details on wiring a power
connection.
Do not disconnect the connectors from the touch panel. The unit must be installed
with the attached connectors before being inserted into the drywall.
Configurations that use the limited access USB port on the side of the connector box
may require a right angle mating connector (not included) for connection to the
device.
Summary of Contents for MXD-430
