Installing Wall-Mount (MXD) Panels
72
Modero X® Series G4 Touch Panels Instruction Manual
Leave enough slack in the wiring to accommodate any re-positioning of the panel.
4.
Remove the knockout on the bottom of the Backbox (FIG. 54) and thread the incoming wiring through the
knockout hole.
5.
Push the Backbox into the mounting surface. Insure that the locking tabs lie flush against the Backbox and that the
Backbox goes freely into the opening.
6.
Extend the locking tabs on the sides of the Backbox by tightening the screws inside the box until snug.
Apply enough pressure to the screw head to keep the box flush with the wall: this ensures that the locking tabs
will tighten up against the inside of the wall.
The Backbox is clear to allow visual confirmation that the tabs have been extended and are gripping the wall,
as well as in assisting with removal if necessary.
For additional strength, #4 mounting screws (not included) may be secured through the holes located at the
top and bottom of the MXD-430 (FIG. 55). In order to prevent damage to the touch panel, make sure that
these are flush with the Backbox.
7.
Insert each connector into its corresponding location on the back of the device.
8.
Test the incoming wiring by attaching the panel connections to their terminal locations and applying power. Verify
that the panel is receiving power and functioning properly to prevent repetition of the installation.
9.
Latch the panel onto the bottom hooks on the Backbox and push it up onto the top snap (FIG. 46).
Press gently but firmly on the ends until the snap “clicks” to lock it down.
The maximum recommended torque to screw in the locking tabs on the plastic
Backbox is 5 IN-LB [56 N-CM]. Applying excessive torque while tightening the tab
screws, such as with powered screwdrivers, can strip out the locking tabs or damage
the Backbox.
FIG. 57
MXD-430 Backbox installed in wall
Locking Tab screws
Knockout
Do not disconnect the cables from the touch panel. The unit must be installed with the
attached connectors before being inserted into the mounting surface.
Summary of Contents for MXD-430
