Upgrading Firmware
77
Modero X® Series G4 Touch Panels Instruction Manual
6.
Once the panel reboots, it will perform the firmware upgrade.
After the upgrade, the device contains the newly loaded version of firmware.
Upgrading from Previous Firmware
X Series panels provide the option to revert the device to the previous firmware run before an upgrade. To upgrade the
device from previously loaded firmware:
1.
From the
Settings
page, select the
Configuration
page.
2.
From the
Configuration
page, select
Admin
.
3.
From the
Admin Configuration
page, select
Install Firmware
.
4.
In the
Firmware Installation
page, select
Previous
.
5.
The
Confirmation Dialog
box (FIG. 64) will ask “Are you sure you want to install the following firmware?” The
option to choose
Yes
will be enabled after five seconds. Press
Yes
to load the firmware listed, and
No
to return to the
Firmware Installation
popup window.
6.
If you choose
Yes
, the device will retrieve the files and then reboot.
Returning to Factory Default Firmware
X Series panels allow the option to return the device to its original factory default firmware, which may be necessary in
certain situations. To return the device to its factory default firmware:
1.
From the
Settings
page, select the
Configuration
page.
2.
From the
Configuration
page, select
Admin
.
3.
From the
Admin Configuration
page, select
Install Firmware
.
4.
In the
Firmware Installation
page, select
Factory
.
5.
The
Confirmation Dialog
box (FIG. 65) will ask “Are you sure you want to install the following firmware?” The
option to choose
Yes
will be enabled after five seconds. Press
Yes
to load the firmware listed, and
No
to return to the
Firmware Installation
popup window.
If you choose
Yes
, the device will retrieve the files and then reboot.
Upgrading Firmware via NetLinx Studio
Firmware updates to X Series panels can be done via the NetLinx Studio software application. This requires that the
touch panel is connected to a NetLinx Master, and that the Master is on the same network as (or accessible by) the PC
running NetLinx Studio. This is because the firmware file is loaded to the panel through it’s connection to the Master.
FIG. 64
Previous Firmware installation confirmation dialog
FIG. 65
Previous Firmware installation confirmation dialog
Summary of Contents for MXD-430
