25
FIG. 5 displays how the brackets should be attached to the NCITE-813/813A:
Installation
FIG. 5
Rack Mounting the NCITE-813/813A
3. Install the presentation system in the mounting rack by using the mounting screws to affix the unit to the rack. Use four
screws to mount each bracket on the NCITE-813AC. The NCITE-813/813A requires only two screws for each bracket.
NOTE:
You can also rotate the mounting brackets on each type of unit to mount the device to the underside of a surface such as a
table or desk.
4. Connect any applicable wires to the presentation system. Refer to the
Wiring and Device Connections (Incite Devices)
section
on page 22 for wiring diagrams and pinout descriptions.
CAUTION:
DO NOT stand other units directly on top of the presentation system when it is rack mounted, as this will place
excessive strain on the mounting brackets.
Ventilation
ALWAYS ensure that the rack enclosure is adequately ventilated. Do not block any ventilation openings. Sufficient airflow must be
achieved (by convection or forced-air cooling) to satisfy the ventilation requirements of all the items of equipment installed within
the rack.
NOTE:
The maximum operating ambient temperature is 40C (104F).
CAUTION:
When installing equipment into a rack, distribute the units evenly. Otherwise, hazardous conditions may be created by
an uneven weight distribution.
Reliable earthing (grounding) of rack-mounted equipment should be maintained.
The presentation system should not be installed in enclosed spaces. It is recommended that you leave 1 RU of space above the
presentation system when you install it in a rack.
Instruction Manual - Incite Digital Video Presentation Systems
