36
FIG. 33
MIC/LINE INPUTS
RCA output
FIG. 35
AMP OUT CLASS 2 WIRING Output
For standard 8-Ohm speaker loads, connect speakers to the AMP OUT output as displayed in FIG. 36.
Wiring and Device Connections
MIC/LINE INPUTS
Two 3.5mm 3-pin captive-wire MIC/LINE INPUT connectors allow up to two mono microphones to be connected to the presenta-
tion system. Each microphone input supports balanced and unbalanced audio. Each input supports up to 48V of phantom power.
FIG. 33 displays the MIC/LINE INPUTS connectors.
FIG. 34 illustrates wiring connections between the presentation system and a mono RCA output and an XLR output.
NCITE
NCITE
XLR output
FIG. 34
RCA (mono) and XLR output wiring
FOR INICTE VERSIONS WITH AMPLIFIER (FG1901-12, FG1901-16):
CAUTION:
Never use shielded cable for output wiring.
CAUTION:
Never connect the speaker return to the chassis of the Incite, or damage to the device may result.
NOTE:
Custom wiring should only be performed by qualified personnel. Class 2 output wiring is required.
AMP OUT
The AMP OUT amplified audio outputs are available only on the NCITE-813A and NCITE-813AC, and each model offers two sepa-
rate wiring options:
The 4-position captive wire connector provides amplified, variable, mono or stereo audio output.
The two 2-position captive wire connectors provide 70V or 100V mono amplified audio output. Connect a speaker to
either the 70V or 100V terminal, but not both simultaneously. FIG. 35 displays the AMP OUT audio output.
FIG. 36
Connecting speakers to the Amplified Audio output
Instruction Manual - Incite Digital Video Presentation Systems
