98
Ducking:
WebConsole - Switcher Options
Buttons at top – Click Off, Low, Medium, High, or Custom.
L/R Mic – Use the slider bar to adjust (range: 0 to -60).
Attack (ms), Attenuation (dB), Release (ms) and Hold Time (ms) – Adjust the values in the boxes (either enter values or
use the arrows)
Selecting an Audio Test Tone
Selecting a test tone for your input source can help determine if you have your audio devices connected correctly.
Perform these steps to select a test tone:
1. Connect to your Presentation System via WebConsole.
2. Select the
Switcher
tab.
3. On the Switcher page, select the
Configuration
tab (see FIG. 95).
FIG. 95
WebConsole - Switcher Configuration page
4. Select an output on the left side of the WebConsole.
5. Click the
Audio Out
tab.
6. In the Global area, use the
Test Tone Generator
menu to select a test tone.
7. In the Port-Specific area, select
Enable
under Test Tone Enable.
Instruction Manual - Incite Digital Video Presentation Systems
