Enzo System Settings
33
Administrators Guide - NMX-MM-1000 Enzo Meeting Presentation System
System
The SYSTEM heading is used to configure system level parameters. Items covered are as follows:
Date & Time
The Date & Time screen (FIG. 62) lists a set of options for setting the date and time for the Enzo Meeting Presentation System. By
default, the Enzo Meeting Presentation System uses the date and time provided by the network.
The following table lists the options on the Date & Time screen:
Setting the Date and Time
By default, the Enzo Meeting Presentation System uses the network-provided date and time. It is suggested to verify that the date
and time are correct while setting up the device. Perform these steps to set the date and time on the Enzo Meeting Presentation
System:
1.
On the main screen, perform a long mouse click on the Enzo icon at the bottom right of the screen.
2.
On the Settings screen, select
System Settings
.
3.
In the System section, select
Date & Time
.
4.
Enter the security password in the text box that appears, and select
OK
. The default password is
1988
.
5.
Check that the current date and time is correct on the device.
6.
Choose
Select time zone
and select the proper time zone from the provided list.
NOTE:
If the time is set manually in Enzo, not using network time and not connected to a master, then the time setting will not persist
through power cycle. For time to persist through a power cycle it must be set use network time or be connected to a master. If
connected to a master it pull the time from the master.
FIG. 62
Date & Time Screen
Date & Time Options
Automatic Date & Time
A check indicates Enzo automatically retrieves the current date and time from a network.
Set Date
Opens the calendar tool to set the current date. After choosing the correct date, click
Done
.
This option is only available if Enzo is not set to automatically retrieve the date and time from
the local network.
Set Time
Opens the Set Time tool to set the current time. After choosing the correct time, click
Done
.
This option is only available if Enzo is not set to automatically retrieve the date and time from
the local network.
NOTE:
If the time is set manually in Enzo, not using network time and not connected to a
master, then the time setting will not persist through power cycle. For time to persist through a
power cycle it must be set use network time or be connected to a master. If connected to a
master, it pulls the time from the master.
Select Time Zone
Opens the Select Time Zone menu to select a new time zone. The default setting is GMT.
Use 24-hour Format
Indicates whether Enzo is to use a 12-hour or 24-hour clock. Checking the box selects a 24-
hour clock.
Choose Date Format
Opens the Choose Date Format menu to select the date format from the provided list. A
selected option immediately takes effect.
