WebApp
55
Administrators Guide - NMX-MM-1000 Enzo Meeting Presentation System
NOTE:
Audio playback is only supported in Fullscreen mode.
6.
Moderators may sort Senders using the tools provided at the top of the sender list. Sorting can be performed using the
following options:
Sender – Sort the list of senders alphabetically either ascending or descending.
Id – Sort the list by Id number assigned when they connect either ascending or descending.
Display Area – Pulls the four Senders assigned to the quadrants to the top of the list. Other sort methods mentioned above
may not leave active Senders in the viewable area depending on the Id number or name.
WebApp Options
Sender:
The Senders list shows each device connected to MirrorOp on Enzo that the
Moderator may choose from and assign to certain quadrants or the full
display. Assigning a quadrant or full display doesn’t necessarily make the
Sender display any content. Presenting is still under the full control of the
Sender using the MirrorOp app. When senders press “Play” on their app,
their content will then be displayed in the quadrant assigned here. Until
they press play, if assigned to a quadrant, a red “X” will mark the area.
Id:
The MirrorOp app assigns an Id to each presenter as they connect.
Display Area:
The display area reflects the actual Enzo display output by Quadrant or
Fullscreen as assigned by the Moderator. Clicking on one of the Senders,
Moderators can assign a quadrant or full screen display to the sender by
then clicking on the area to display. Up to four quadrants can be populated
with individual Senders at one time.
Show Connection Info:
Clicking on
Show Connection
Info
allows Moderators to toggle the login
credentials (IP address and passcode) back onto the Enzo display during a
presentation (FIG. 106) so late comers can get connected to present.
Pressing it once will make it appear on screen and pressing it a second time
will remove it from the screen. See
Disconnect All
Causes all existing connections to be booted from MirrorOp.
Conference Control: (optional)
The Conference Control option is available for the Admin user by default
and can be made available for the Moderators only from the Admin account.
ON -
Presenters can only connect to MirrorOp but cannot begin presenting.
They will see a message saying “Projector is in Conference mode. Only the
conference Admin can allow someone to project.”
OFF -
Presenters/Senders may connect to MirrorOp and begin presenting
from their devices. Moderators may still assign full screen or quadrants to
the presenters.
Max Moderators: (optional)
The Max Moderators option is available for the Admin user by default and
can be made available for the Moderators, only from the Admin account.
This option enables up to three moderators to control the presentations.
Note:
Max Moderators includes Admin and Moderator users, up to 3 total.
Passcode: xxxx
This is the current passcode, displayed so presenters can use it to connect.
Randomize Passcode:
The passcode for connecting to MirrorOp through Enzo is displayed as a
courtesy. Click
Randomize Passcode
to have the system randomly generate
a new passcode which must be entered on the presenting device to connect
to Enzo.
Launch MirrorOp
If MirrorOp isn’t launched on Enzo, the Moderator may launch it remotely
from the WebApp using this option. If Enzo is not in a session, selecting
Launch MirrorOp will take Enzo into session and launch the MirrorOp app.
FIG. 105
Sorting Senders Ascending or Descending
Use the sorting header to
arrange Senders in the list.
