Installation
12
Administrators Guide - NMX-MM-1000 Enzo Meeting Presentation System
Enzo Power-up
When power is applied, the POWER LED on the front panel appears red and then blinks green while the device is booting. When the
device is finished booting and the device is ready for use, the LED remains solid green. The device usually takes 20-30 seconds to
boot. When booting is complete, the NMX-MM-1000 opens to the Enzo desktop (FIG. 16).
Locating the Enzo IP Address
On connection, a diagnostics screen can be accessed on which the IP address, Ethernet switch status, etc. can be viewed on the
connected video output. Perform the following steps to locate the IP address of the device. For further details on navigating the
Enzo interface, refer to the
Enzo Users Guide
.
1.
On the Enzo opening screen, select
Start New Session
.
2.
Press
F12
.
3.
Select
System Settings
.
4.
The IP address of the Enzo unit appears in the Device area (see FIG. 17) under the
Device Info
selection.
FIG. 16
Enzo Desktop
FIG. 17
System Settings - Device Info Screen