Installation
18
Radia Lighting Control System
4.
Power up the controller enclosure and wait for the controller's green status LED to go off after
approximately 1 minute.
5.
Using a non-conductive rod or wooden one-quarter inch dowel rod (approximately 12" long)
press the RESET button located on the controller module circuit board.
6.
At the breaker panel, remove power from the controller enclosure.
7.
Remove the jumpers from the dry contact closure connector.
8.
Reconnect the AXlink and PROlink connections.
9.
Power up the controller enclosure.
External power
The following table lists the modules that use most of the operating power a AMX Lighting control
module can supply. They may require extra power from the AXlink connection, or an external
power supply connected to the control module or module(s) when using multiple modules.
If extra power is required, connect an auxiliary 12 VDC power supply as shown in FIG. 23.
External Modules
RDM-HSW
RDM-MR
RDM-SWM
RDM-2HSW RDM-2MR
RDM-2SWM
RDM-3HSW RDM-3MR
RDM-3SWM
RDM-HFDB RDM-MR35 RDM-DPSM
RDM-HDC
RDM-MR60
FIG. 23
Auxiliary power connection
Auxiliary 12 VDC
power supply
+ -
+
-