18
12.
DIAGNOSTICS
The microprocessor of your scooter uses flashes and beeps to alert and inform you of
any faults or conditions. These diagnostics and your scooter’s serial number can be
found under the battery packs, providing you easy access to this resource. If possible,
refer to this information prior to contacting your authorized
Amylior
dealer.
1
flash
/
beep
2
flashes
/
beeps
• Indicates the battery voltage is below the
required operating voltage of the scooter.
• The batteries need to be charged.
• Your scooter will continue to
function at reduced speeds. As the
voltage drops you will eventually
experience a power loss.
• Fix this by charging your
scooter’s batteries.
• Indicate the battery voltage is too
low for the scooter to operate.
• At this voltage your scooter
will cease operation.
• Charge your batteries.
• If you have charged the batteries and
the condition continues, one or both
scooter batteries may be faulty or there
may be a problem with your charger.
• Consult your authorized
Amylior
dealer for assistance.
3
flashes
/
beeps
4
flashes
/
beeps
• Indicate to contact your authorized
Amylior dealer.
• Indicate that the motor
control board is overloaded
and/or overheated.
• This can occur if you have been driving
up an incline above the recommended
6° for an extended period or if you are
carrying a payload higher than the
recommended weight capacity
of 350 lb (159 kg).
• Your scooter will not operate
until the motor control board
cools back to its operational
temperature range.
• Fix this by turning off the key
switch and allowing the scooter
to cool down for 10 minutes.
