ACCESSORY INSTALLATION - STELLA (
Cont’d
)
4
IG
–
PD-A20608
–
Rev01
4.
Footrests
Tools: 4 mm and 6 mm Allen keys
4.1 Before installing footrests, verify that the tension of the spring on each footrest is adequate. The
footrest activation tension is adjusted by loosening or tightening screw inside footrest with a
6 mm Allen key, as shown below.
Required tension: The footrest should not be too hard to lift and swing away.
4.2 Remove both screws holding the cap in place on each side of the tube with a 4 mm Allen key.
4.3 Remove cap.
4.4 Insert footrest into fork recess.
4.5 Insert screws one after the other, without fully tightening to make
sure that the screws are properly aligned.
4.6 Tighten both screws with the 4 mm Allen key.
