AMYPOWER ALLTRACK R3 & R SERIES - Owner’s Manual (Rev. A)
21
J. Power Tilt /Seat Lift Combo (Standard Operating Instructions)
WARNING!!!
Make sure the wheelchair is on a level surface before proceeding
with either Tilt or Lift mode and driving in reduced speed while lifted.
Tilt and Seat Lift options are programmed to operate separately.
The ability to tilt while the seat lift is elevated is not possible.
Bypassing this programming may cause severe injury.
DUAL ACTUATOR TOGGLE SWITCH
Increasing / Decreasing Seat Lift Height
Pull the toggle switch (located next to the wheelchair joystick)
backward toward the rear of the wheelchair until the desired Lift
Height is achieved, then release. To change direction, release the
toggle switch to the neutral position for a minimum of 1 second, and
pull back the toggle switch in the same direction toward the back of
the chair until you achieve the desired height, then release.
DUAL ACTUATOR TOGGLE SWITCH
Increasing / Decreasing Tilt Angle
Push the toggle switch
(located next to the wheelchair joystick) forward toward the front of
the wheelchair until the desired tilt angle is achieved, then release.
To change direction, release the toggle switch to the neutral
position for a minimum of 1 second, and push forward the toggle
switch in the same direction toward the front of the chair until you
achieve the desired tilt angle, then release.
Driving in Reduced Speed
Is a feature designed to allow the user to drive the wheelchair at a
reduced speed while lifted up to 11”. When lifted, the drive speed is
then reduced to 30% of its original setting. Full drive speed is
achieved when the seat lift is down to its lowest position.
Drive lock-Out
Is a safety feature designed to prevent the wheelchair from being
driven while in a tilt angle over 15 degrees relative to the vertical
position.
DANGER!!!
Never operate the wheelchair while in tilt mode over 15
degrees relative to the vertical position. Never operate the seat lift
when the wheelchair is in any slope. In reduced speed, the
wheelchair must be driven on a level surface relative to the vertical
position. If the drive lock-out does not stop the wheelchair from
operating when in a tilt angle over 15 degrees, or if it allows the seat
lift to elevate while tilted, or if the reduced speed does not slow the
wheelchair’s drive speed to 25% of its original settings, have the
wheelchair or power seat lift system serviced by an authorized
dealer or qualified technician.
