46
While shifting the gear;
•
Do not press on the gas pedal
•
The speed of the engine should be less than 900 rpm
•
The vehicle must be in stop position
•
It should be pressed on the brake pedal
•
It should be pressed on the gear which shall be selected
The transmission does not allow to select the gear in the following cases and its light
flashes when pressed on the button.
•
If pressed on the gas pedal
•
If the engine speed is over 900 rpm
•
If the vehicle is moving at the speed of more than 3 km/h and if it is moving in the
opposite direction of the desired
•
If the transmission oil heat is less than - 20 °C
Pull your foot from the brake pedal after 1 - 2 seconds of gear selection, the vehicle shall
move. When the foot is pulled from the brake pedal while the vehicle is uphill, the
transmission brakes so as to prevent the vehicle from rolling back.
Downhill
While driving downhill, in order to limit the gear when needed it is to be limited the gear
increase by selecting 1, 2 or 3 numbered gears.
Kickdown Specification
When high engine power is needed, the gear is reduced with the specification of
kickdown. To do so, it is to be pressed on the gas pedal until passing the kickdown
activation point. The usage of kickdown specification increases the fuel consumption.
Summary of Contents for CITIPORT E6 2019
