55
Preheater is in the cupboard behind the rear wheels. The 3-way valve is closed only
for preheating the motor coolant (it is to be pressed on – position). The desired
programming may be adjusted with the program clock. The 3-way valve is opened in
order to support heating system (it is to be pressed on + position).
The filter valve should be open while starting the preheater. The filter must be cleaned
in periodic maintenances.
Check if there is a fuel leakage in the fuel line and on the preheater before
starting. The air adjustment of the preheater should be realized in very
cold regions and in regions higher than the sea level. If the air adjustment
is not realized, a black smoke comes from the preheater exhaust (the air
adjustment is only performed by authorized preheater service). The
preheater should not be operated when the heating system was in
summer position (when the manual valves were off).
Additionally, after closing the preheater, battery switch and main power switch should
not be closed. The preheater takes itself to cooling for 5 minutes after being closed.
The preheater can damage if the power switches were closed.
The preheater may close itself due to overheating for any reason. If the
preheater closes itself because of overheating several times, the control
circuit closes the heater automatically. Apply to the authorized heater service
for opening the heater and solving the problem.
Preheater is commanded with the control on the console above the driver.
Summary of Contents for CITIPORT E6 2019
