11
RECOMMENDATIONS / WARNINGS
•
Use only specified fuel (EN590 suitable sulfur content maximum 10ppm) in your
vehicle.
•
Use diesel exhaust emission fluid suited for DIN70070.
•
Do not load your vehicle over its passenger capacity and do not change the places of
the seats. Our factory is not responsible for the problems arising as a result of a change
in the load balance of the vehicle.
•
Examine exhaust pipe from time to time. If you see a damage (for example, a damaged
connecting member caused by abrasion or a hole or a crack, corrosion and leaks in
pipes ports), take it to the nearest authorized service for control and maintenance.
•
Control the wheel pressures frequently and be sure that they are always at the right
value.
•
In order to control tire degradations, get pre-layout settings to be controlled in every
20000 km.
•
Control the main and dipped beam settings, do not drive with defective headlights.
•
Control brake, parking and plate lamps frequently, do not drive with defective or mud
covered brake, parking and plate lamps.
•
Take care of the maintenance of your vehicle to be done in authorized services in time
and regularly in order to provide maximum performance in your vehicle.
•
When the fluids such as waste oil, brake fluid and antifreeze you use in your vehicle
and scrap batteries are thrown away indiscriminately, this gives great damage to the
environment. Take care of eliminating such hazardous wastes in accordance with
environmental regulations.
•
Empty cans, bottles or other articles rolling on the floor, is extremely dangerous, be
sure that especially the floor around the driver’s seat is clean and tidy.
•
Be sure that there are no combustible materials under or around the vehicle before
starting it. The existence of such materials may cause fire.
•
Be sure that you had trimmed the seat, steering wheel and the mirrors suitable for your
correct driving position before the drive.
•
Always wear your seat belt.
•
Take care of front and side windows to be clean, keep the blinds not hindering your
visibility and driving.
•
Do not raise the speed of the engine before it was heated enough.
•
Drive your vehicle carefully by complying with traffic rules and the road condition.
•
If you realize an abnormality in a wheel during the drive, stop immediately in a safe
place.
•
If you go on your way with a deflated tire, this may cause the breaking of the bolts
and the remove of the wheel by applying too much force to the wheel studs.
•
Drive at a constant speed to the utmost. It is the waste of fuel to heat the engine
overmuch and to make the engine high-speed.
Summary of Contents for CITIPORT E6 2019
