75
11.
Check whether the cabin heater temperatures have risen. Total air relief for cabin
heater and A/C system lasts for about 15 minutes. Make sure that air relief is
completed.
12.
Close the manual valves on the waterlines tied to cabin heater and A/C units (engine
water inlet and outlet).
13.
Restart the engine and run the engine at high speed until cooling water temperature
has reached the thermostat opening temperature values. Radiator frille may be
covered with a cloth (linoleum etc.) to reach the high temperature quicker.
14.
It must be continued to run the engine at raised idle speed for 5 minutes and keeping
the engine cooling water thermostat opening temperature (90-95°C) range once
these temperatures have been reached.
15.
Run the engine in low idle for 1 minute before shutting off, which enables
components such as piston, cylinder, bearings and turbocharge to cool adequately.
16.
Shut off the engine and keep adding cooling fluid up to the maximum level of the
expansion tank.
17.
Restart the engine at raised idling speed and increase the engine cooling water
temperatures to thermostat opening temperature values 90-95°C range and keep
this temperature level for 1 minute.
18.
Run the engine in low idle for 1 minute before shutting off, which enables
components such as piston, cylinder, bearings and turbocharge to cool adequately.
19.
Shut off the engine and fill the cooling fluid if it is possible to fill from expansion tank.
If 1 lt or more cooling fluid can be added to the system, repeat the operations from
the 17
th
article.
20.
Check whether there is cooling fluid leakage in layout and main components during
filling and air relief processes.
21.
It is the customer’s responsibility to daily check the cooling fluid level and fill if
required.
OIL FILTER REPLACEMENT
Oil filter can be reached from left side lower cap. For the replacement of oil filter;
1.
Clean the oil filter cap and remove the filter with the help of filter removal attachments
2.
Fill the new filter which would be inserted with clean engine oil
3.
Grease a thin layer of engine oil on oil filter o-ring
4.
Tighten the oil filter with hand until it touches to the rubber gasket surface, then
tighten ¾ revs more with filter attachments
5.
Start the engine and check the filter for any leaks.
Summary of Contents for CITIPORT E6 2019
