76
FUEL FILTER REPLACEMENT
Fuel filter can be reached from left lower cap. For the replacement of fuel filter;
•
Remove the fuel filter
•
Remove the filter element made out of paper from the filter
•
Remove the o-ring from filter
•
Insert the new filter element into the filter properly
•
Insert the new o-ring to the filter
•
Lubricate the fuel filter o-ring with a clean lubrication oil
•
Fill the fuel filter with fuel
•
Insert the fuel filter to the fuel filter head in a way holded by a cog
•
Tighten the filter with 32 Nm torque
FUEL WATER SEPARATOR
Fuel water separator is located on the middle
region mounted on the body when the rear door
of the vehicle is opened. Its fuction is to provide
the efficient usage of fuel by distilling the water
in fuel. In order to empty the water piled up in the
fuel water separator filter;
•
Open the water drain tap by turning
•
Tighten it again in a controlled manner while passing from water to fuel
•
Check whether there is a leakage after starting the engine.
For the replacement of fuel water separator filter;
•
Remove the connection cable of fuel water control sensor can
•
Remove the fuel filter
•
Empty the fuel filter, remove the fuel water control sensor can from the fuel filter
•
Check if there is a damage or a crack on the sensor can
•
Insert the fuel water control sensor can to the new filter
•
Lubricate the fuel filter o-ring with clean engine oil.
•
Replace the filter.
Summary of Contents for CITIPORT E6 2019
