87
USE OF THE JACK AND TIRE REPLACEMENT
The jacking points of the vehicle are on the body and behind the front and rear wheels.
The Usage of Jack
•
Be sure that the drain plug is tightened
•
Use its own jack handle in order to hold the jack
•
For downing the jack, turn the drain plug two turns to left.
Replacement of Wheels
•
Put a chock to the wheel cross on the opposite side of the wheel you would hold
•
Loosen the wheel nuts on the side of the wheel which would be replaced, but
do not remove from its place.
•
Hold the vehicle from the jacking point behind the wheel which would be replaced
till the wheel is completely off the ground
•
Remove the wheel nuts and remove the wheel
•
Insert the spare wheel
•
Get the cavity of the wheel nuts and ensure the wheel to fit into its slot
•
Tighten the wheel nuts in cross-order and at three stages with
600 +/- 60 Nm
torque
Down the vehicle by loosing the drain plug slightly.
Be sure that the jack is placed on a flat and a solid ground. Do not start the
engine when the vehicle is on jack. Do not crawl under the vehicle while
using the jack. Debus the passengers during the replacement of wheels, be
sure that the gear is in the parking position, pull the handbrake and light the
hazards.
NOTE :
If the pressure of the wheel reduces continuously, there may be an object stuck
in the tire. Additionally, it has to be controlled that whether there had been a leakage
from the rims or valves.
Summary of Contents for CITIPORT E6 2019
