Anaheim Automation Security+ 3850AD, Owner'S Manual

35

1.  Press and release the “learn” button 

on motor unit. The learn indicator 
light will glow steadily for 30 
seconds.

2.  Within 30 seconds, enter a four digit 

personal identification number (PIN) 
of your choice on the keypad. Then 
press and hold the enter button.

3.  Release the button when the motor 

unit lights blink. It has learned the 
code. If light bulbs are not installed, 
two clicks will be heard.

To Add, Reprogram or Change a Keyless Entry PIN

NOTE:

 Your new Keyless Entry must be programmed to operate your garage door opener.

USING THE “LEARN” BUTTON 

  USING THE DOOR CONTROL

To change an existing, known PIN

If the existing PIN is known, it may be changed by one 
person without using a ladder.

1.  Press the four buttons for the present PIN, then press 

and hold the # button.

   The opener light will blink twice. Release the # button.

2.  Press the new 4-digit PIN you have chosen, then 

press Enter.

The motor unit lights will blink once when the PIN has 
been learned.

Test by pressing the new PIN, then press Enter. The door 
should move.

To set a temporary PIN

You may authorize access by visitors or service people 
with a temporary 4-digit PIN. After a programmed number 
of hours or number of accesses, this temporary PIN 
expires and will no longer open the door. It can be used to 

close

 the door even after it has expired. To set a 

temporary PIN:

1.     Press the four buttons for your personal entry PIN 

(not the last temporary PIN), then press and hold the 

✽

 button.

   The opener light will blink three times. Release the 

button.

2.  Press the temporary 4-digit PIN you have chosen, then 

press Enter.

  The opener light will blink four times.

3.  To set the number of 

hours

 this temporary PIN will 

work, press the number of hours (up to 255), then 
press 

✽

.

OR

3.  To set the number of 

times

 this temporary PIN will 

work, press the number of times (up to 255), then 
press #.

The opener light will blink once when the temporary PIN 
has been learned.

Test by pressing the four buttons for the temporary PIN, 
then press Enter. The door should move. If the temporary 
PIN was set to a certain number of openings, remember 
that the test has used up one opening. To clear the 
temporary password, repeat steps 1-3, setting the number 
of hours or times to 0 in step 3.

1.  Press the PROG <Learn> button on 

the door control.

2.  Press the PROG <Learn> button 

again to confirm Learn Mode.

3.  Enter a four digit personal 

identification number (PIN) of your 
choice on the keypad. Then press 
enter.

4.  When the motor unit lights blink, it 

has learned the code. If light bulbs 
are not installed, two clicks will be 
heard.

NOTE: 

This method requires two people if the Keyless 

Entry is already mounted outside the garage. 

LOC

K

LIGHT

LOC

K

LIGHT

One Button Close: 

Opener can be closed by pressing only the ENTER button if the one button close feature has been 

activated. This feature has been activated at the factory. To activate or deactivate this feature press and hold buttons 1 
and 9 for 10 seconds. The keypad will blink twice when the one button close is active. The keypad will blink four times 
when one button close is deactivated.