A n a Je t® 3 0 0 0 /6 0 0 0
Q U IC K S T A R T IN S T A L L A T IO N G U ID E
V .1 .0
1
PREPARE
PRINTER
ENVIRONMENT
•
Reliable Power source/outlet. Consider using a UPS if your area’s power is unreliable
•
Electronic hygrometer/thermometer (to monitor the relative humidity of the room the
printer is operating in). Keep it near the printer at all times. 61°F to 90 °F (16°C to
32°C)
•
Humidifier to increase humidity if it falls below 45% humidity. Humidity needs to
remain between 45% to 80% RH, non-condensing.
•
Heat Press or tunnel dryer for heat curing the ink (THIS NEEDS ITS OWN CIRCUIT)
•
Stable, Sturdy, and Level Table for the 180 lb./81.6 Kg printer.
•
PC computer with Windows XP, Vista, Windows 7, Windows 8 or Windows 10
operating system.
•
Graphics software installed in the PC, such as Photoshop, CorelDraw, Photoshop
Elements or Illustrator.
•
High Volume Low Pressure (HVLP) electric sprayer or other type of sprayer for
applying pretreatment for dark garments.
2
UNPACK
THE PRINTER
•
Keep shipping box right side up (see arrows)
•
Remove poly wrap and strapping
•
Remove top lid, upper foam and separator sleeve
•
DO NOT LIFT BY PRINT TABLE FRAME, LIFT FROM BOX WITH HELP OF 4 PEOPLE
•
Place printer on your table
•
Unlatch top cover by pressing button below control panel (see diagram) to lift top
cover
•
IMPORTANT!
Remove BOTH shipping retainer brackets before powering on the
printer
. Remove the 3 thumb screws holding the Table and Print Carriage in position
(See diagram below). Keep the brackets and 3 thumb screws for future use for
shipping your printer)
, you should now
be able to move the table carriage
freely back and forth.
3
LEVEL THE
PRINTER
•
Locate the six adjustable printer
feet under the printer
•
Open top cover. Place a “torpedo-
style level” (included) on top of the
front metal rail left to right. Adjust
left and right printer feet to level,
then adjust middle foot for
stability.
•
Now, level the printer front to rear
by placing the level on the lower
metal rail behind the print table,
adjust the printer feet as needed to
level the printer.
Remove level from
printer when completed
.
