13
Next step is to use double sided adhesive tape to position the Link9 Radio Receiver behind the CC3D
Flight Controller as shown in diagram below.
The SBus Port is horizontal port in bottom right corner of the image below and left to right the pins are;
signal, positive and negative.
Connect the Black, Red and Yellow wires from the CC3D “Main Port” to the SBus port of the Receiver,
in the sequence shown above (Yellow = Signal, Red = Positive, Black = Negative)
Now you should fix the VTX in place (as shown below) using double sided adhesive tape
To avoid potential damage to your VTX you should attach the antenna to it now, because if you connect
power to the VTX without the antenna in place – the VTX can be permanently damaged. With the
antenna in place, connect the VTX Power lead to the red plug at the front of the Anakin Club Racer.
