19
12. On the Sensor Calibration Procedure Screen,
ensure that the CC3D is on a flat level surface,
where it will not be subject to any movement or
vibration, then Click “Calculate” (and ensure the
CC3D is not moved until the calibration process is
completed), then Click Next
13. On the ESC Calibration Procedure Screen,
double check that your battery is not connected
and no propellers are attached, then tick the 3
boxes and Click Start
In the next step we will apply power to spin the motors, so ensure that your motors are clear of anything
that could get wrapped around them or cause a danger to yourself. Make sure your propellers are not
installed.
14. When the screen changes (as shown below)
connect your battery, wait for the multi-tone
calibration beeps, then Click the “Stop” button
Wait for more multi-tone beeps, then you can
disconnect your battery and Click Next
