8
ADDITIONAL ITEMS REQUIRED TO COMPLETE
(with our recommendations)
Radio Transmitter & Receiver
• Link9 Mode 1 Radio & Receiver - SKH02-001-M1
• Link9 Mode 2 Radio & Receiver - SKH02-001
3-4S Lipo Battery and a Battery retaining strap
• Anakin Lipo 3S 1300mAh 35C – SKH08-012
• Anakin Lipo 3S 1300mAh 65C – SKH08-013
• LIPO 4S 1300mAh 65C – SKH08-014
• LIPO 4S 1800mAh 65C – SKH08-020 (6” Club Racer model only)
Video Transmitter (for camera and FPV use)
• VTX 25-600mW 40CH Race Band SKH04-015
REQUIRED TOOLS AND EQUIPMENT
• Soldering Iron
• Double sided adhesive Tape
• 2mm Hex Screwdriver
• 8mm Spanner
• 15mm Heat shrink Tubing (20 cm length)
• Male Futaba Servo type plug (with approximately 5cm of positive and negative wires connected)
The following instructions assume that you are using Sky-Hero components (Camera, VTX and Radio
equipment), however towards the end of the manual there is also some basic information over the use
of alternative equipment
If you are using the Sky-Hero supplied Camera, then we recommend that you either solder the Camera’s
black and red wires directly to the 5v filtered output of the PDB or you can remove the yellow cable
from the Camera’s Servo type connector then use the Camera’s servo type connector to connect to the
M6 port on the CC3D.
If you are using your own camera, you should choose an appropriate power source, based on the voltage
and current requirements of your camera. If you use the Camera output from the PDB, check that the
Lipo battery voltage is not higher than your camera’s maximum input voltage.
NOTE: if you use a 4S Lipo and the FX795T-2 or FX795T-6 (200 / 600mW) VTX,
we recommend to use a 12v Voltage Regulator between main board and VTX
