Rev 05 Jun 2013 16:37 | Page 12
Figure 9. SPI Controller, New DUT Button
In the ADCBase 0 tab of the SPIController window, find the CLOCK DIVIDE(B) box (see Figure
3.
10). If using the clock divider, use the drop-down box to select the correct clock divide ratio, if
necessary. The Nyquist Clock is selected by default. If using the RF Clock, make sure to configure
the device in this tab. For additional information, refer to the data sheet, the
, High Speed ADC SPI Control Software, and the
, Interfacing to High
Speed ADCs via SPI.
