Rev 13 May 2013 17:57 | Page 8
Default Mode
To operate the device under test (DUT) using the SPI, follow the jumper settings for J302 as shown in
Table 1.
How To Use The Software For Testing
Setting up the ADC Data Capture
After configuring the board, set up the ADC data capture using the following steps:
Open VisualAnalog on the connected PC. The appropriate part type should be listed in the status
1.
bar of the VisualAnalog – New Canvas window. Select the template that corresponds to the type
of testing to be performed (see Figure 3, where the
Figure 3. VisualAnalog, New Canvas
Window
After the template is selected, a message appears asking if the default configuration can be used
2.
to program the FPGA (see Figure 4). Click Yes, and the window closes.
Figure 4. VisualAnalog Default
Configuration Message
To change features to settings other than the default settings, click the Expand Display button,
3.
