to FMC and the clock source jumper (CLK SRC/P3) is set to crystal (XTAL). The USB connection
on the AD9739A-FMC-EBZ and the SMA Clock Input (SMA CLKIN/J3) are not used in this
example. After the hardware setup, turn the power on to the ML605.
Start IMPACT, and initialze the JTAG chain. The program should recognize the Virtex 6 device for
ML605 (see screenshot below). Start a UART terminal (set to 57600 baud rate) and then
program the device.
If programming was successful, you should be seeing messages appear on the terminal as
shown in figure below. After programming the AD9739A and ADF4350, the program continously
monitors the MU Controller and LVDS Receiver lock status. If either of them are out of lock, the
program quits itself with an error. You may also quit the program by pressing 'q' and then the
'Enter' key.
The specturm analyzer output is shown below.
Page 4 of 12
AD9739A Native FMC Card / Xilinx Reference Designs [Analog Devices Wiki]
5/22/2012
http://wiki.analog.com/resources/fpga/xilinx/fmc/ad9739a?force_rev=1
