ADV8005 Hardware Reference Manual
UG-707
svsp_autocfg_output_vid[7:0]
, Secondary VSP Map,
Address 0xE661[7:0]
This register is used to set the output timing VIC. If this register is 0, SVSP will use values in registers of svsp_dp_decount,
svsp_dp_hfrontporch, svsp_dp_hsynctime, svsp_dp_hbackporch, svsp_dp_activeline, svsp_dp_vfrontporch, svsp_dp_vsynctime,
svsp_dp_vbackporch, svsp_dp_hpolarity, svsp_dp_vpolarity and svsp_vout_fr to set output video.
Function
svsp_autocfg_output_vid[7:0]
Description
0x00 (default)
Custom output video;
0xXX
Output timing VIC
lists all the supported video timings and their VID. The 59.94/23.97 Hz timings have the same VID as the corresponding 60/24 Hz
timing in the table.
Table 29: SVSP Supported Output Video Timing and VID
Video Timing
VID
CEA
640x480p60
1
720x480p60
2 or 3 or 14 or 15 or 35 or 36
720(1440)x240p60
8 or 9
720(2880)x240p60
12 or 13
1280x720p60
4
1920x1080i60
5
720x480i60
6 or 7 or 10 or 11
1920x1080p
16
720x576p50
17 or 18 or 29 or 30 or 37 or 38
1280x720p50
19
1920x1080i50
20
720x576i50
21 or 22 or 25 or 26
720x288p50
23 or 24 or 27 or 28
1920x1080p50
31
1920x1080p24
32
1920x1080p25
33
1920x1080p30
34
720p100
41
576p100
42 or 43
720p120
47
480p120
48 or 49
576p200
52 or 53
480p240
56 or 57
VESA timing
VGA
200
SVGA
201
XGA
202
WXGA
203
SXGA
204
WXGA-2
205
UXGA
206
WXGA-3
207
WUXGA
208
Note
: The SVSP does not support the following formats;
10.
1280x720p @ 23.97/24 Hz (CEA VIC 60)
11.
1280x720p @ 25 Hz (CEA VIC 61)
12.
1280x720p @ 29.97/30 Hz (CEA VIC 62)
If overscan, crop or album mode is employed, the required blocks should be configured manually by enabling the corresponding enable bits,
such as
, to enable the VIM crop block.
Rev. A | Page 137 of 317
