Once drivers are installed for the Interface Board, one should use the same USB port
each time the manager is connected to the computer. If a different USB port is used,
the setup procedure will need to be repeated for that port.
The Eterna Evaluation and Development Board Set require Windows 7 or Windows
XP with SP3, or later versions of Windows.
For details regarding the FTDI drivers installation, please refer to the FDTI
documentation and the
Eterna Serial Programmer Guide
.
Setup
For details on operating the Eterna Evaluation & Development Board Set in a
network, please refer to the starter kit documentation (
SmartMesh IP Easy Start
Guide
or
SmartMesh WirelessHART Easy Start Guide
).
Warning
The Eterna Evaluation & Development system includes Lithium batteries.
Batteries can explode, ignite, leak, or cause personal injury if not used or disposed of
properly. Do not open batteries, discard in fire, nor heat above 100°C (212°F). Do
not recharge the batteries, install them backwards, install used or other battery
types, nor expose battery contents to water.
6 A
NALOG
D
EVICES
,
I
NC
.
C
ONFIDENTIAL
DC9006A
AND
DC9004B
U
SER
G
UIDE
