UG-977
EVAL-AD5326DBZ User Guide
Rev. 0 | Page 4 of 14
EVALUATION BOARD SOFTWARE QUICK START PROCEDURES
INSTALLING THE SOFTWARE
evaluation software is compatible with Windows®
Vista (64-bit/32-bit) and Windows 7 (64-bit/32-bit).
Install the software before connecting the
board to the
USB port of the PC to ensure that the
board is
recognized when it connects to the PC.
evaluation software, take the following
steps:
1.
Start the Windows operating system.
2.
Download the installation software from the
evaluation board page.
3.
Run the
setup.exe
file from the installer folder if it does not
open automatically.
4.
After the installation is complete, power up the evaluation
board as described in the Power Supplies section.
5.
Connect the
evaluation board to the
controller board and connect the
board to
the PC using the USB cable included in the evaluation kit.
6.
proceed through any dialog boxes that appear to finalize
the installation.
RUNNING THE SOFTWARE
To run the program, do the following:
1.
Connect the evaluation board to the
board and
connect the USB cable between the
board and the PC.
2.
Power up the evaluation board as described in the Power
Supplies section.
3.
From the
Start
menu, click
All Programs
,
Analog Devices
,
AD5326 Evaluation Software
.
If the
board is not connected to the USB port when the
software is launched, a connectivity error displays (see Figure 2).
Simply connect the evaluation board to the USB port of the PC and
wait a few seconds. When the
board is detected, the display
is updated (see Figure 3).
Alternatively, the software can be used without an evaluation
board. The software runs in simulation mode displaying expected
outputs based on the input data. The main window of the
evaluation software then opens, as shown in Figure 4.
1
444
8-
0
02
Figure 2. Connectivity Error
1
4448
-003
Figure 3. Hardware Select
