ATA Pro
Technical Manual
Int. Approved
Document ref: HEL-810-12
December 2017
Page 14 of 27
Copyright © 2017 Analox Ltd. All Rights Reserved.
Commercial in Confidence
5.5
Safety Information
When the life of the battery has expired it should be disposed of safely in
accordance with local regulations.
When the life of the O
2
sensor has expired or it is leaking or otherwise damaged
it must be disposed of safely in accordance with local regulations.
The O
2
sensor contains KOH (Potassium Hydroxide) solution which is hazardous
and can have the following effects:
Skin
Potassium Hydroxide is corrosive - skin
contact could result in a chemical burn.
Ingestion
Can be harmful or FATAL if swallowed.
Eye
Contact can result in the permanent loss of sight.
5.6
First Aid Procedures
Skin
Wash the affected part with a lot of water
and remove contaminated clothing. If
stinging persists get medical attention.
Ingestion
Drink a lot of fresh water. Do not induce
vomiting. Get medical attention.
Eye
Wash with a lot of water for at least 15
minutes and get medical help immediately.
5.7
Sensor Handling Information
ATA pro
oxygen sensors are normally supplied in sealed packs. Before the pack
is opened check that the sensor has not leaked. The sensors are themselves
sealed and do not under normal circumstances present a health hazard however
if leakage of the Potassium Hydroxide electrolyte has occurred use rubber gloves
and wear chemical splash goggles to handle and clean up. Rinse contaminated
surfaces with water.
