22
User manual Zitzi Guppy G2
www.anatomicsitt.com | +46 11 16 18 00
Footrest
Mounting of footrest
Use the supplied screws (C) to mount the brackets to the footrests. The brackets
are mounted as shown with four screws / brackets in the front edge of the seat part
plate. Note that the locking screws (B) must point inwards/downwards.Mount the
footrest square tube (A) in the footrest brackets under the front part of the seat
plate. Lock the footrest with the locking screws (B) on both sides.
Adjusting the angle of the knee-joint
When the footrest is mounted in the seat part plate, it is possible to adjust the
footrest at the knee joint. Loosen the levers (E) slightly and adjust the footrest to
the desired angle. Tighten the levers.
Safety stop
Safety stop (D) in the form of a rail pin is mounted in the bottom of footrest profile.
The safety stop can also be used to find back to a preset height position.
Adjusting the height of the footrest
When the footrest is mounted in the seat part plate, it is possible to adjust the
footrest at the ankle. Release the levers (F) slightly and adjust the footrest to the
desired height. Tighten the levers.
TIP!
Mount an extra safety stop above the footrest in the footrest profile
groove to easily find an alternate height position (for example, with or
without shoes).
D
F
E
A
B
C
Summary of Contents for Zitzi Guppy G2
Page 1: ...User manual Zitzi Guppy G2 EN ver 2 0 2020 04 15 ...
Page 9: ...9 User manual Zitzi Guppy G2 www anatomicsitt com 46 11 16 18 00 D B A C ...
Page 11: ...11 User manual Zitzi Guppy G2 www anatomicsitt com 46 11 16 18 00 A B C ...
Page 19: ...19 User manual Zitzi Guppy G2 www anatomicsitt com 46 11 16 18 00 C A B F E D ...