Power Wiring
ANCA Motion
D-000088 Rev 09
47
6
6.8.2.1.2
D2109 Cable Shielding
Use an Armature Bracket in order to terminate the shielded cable assembly.
The Armature Termination Bracket assembly consists of the following parts:
Armature Termination Bracket
EMC Saddle Clamp
3 x M4 screws
1 x M6 screw
Shield for bracket ordering details.
Clamp the Armature Termination Bracket down as shown below using the 2 x M4 existing screws that
came with the drive. Tightening Torque 2.5Nm max.
Carefully remove the Armature cable sheath to expose the metal braid. Expose approximately 25mm of
braid length. Refer to
section 6.8.2.1.4
for details on this process and suggested tools.
The position of the exposed braid is to coincide with the EMC Saddle Clamp and the metal bracket as
shown below to provide sufficient contact for termination.
Tighten the Saddle Clamp screw to 0.5Nm as recommended by the manufacturer.
Fit the armature plug into the armature connector on the drive.
Ensure that the Armature Cable Earth wire is connected to an M4 ring lug using one M4 screw from the
Armature Termination Bracket assembly kit, and connect to the bracket as shown below. Maximum
tightening torque is 1.5Nm.
The Armature Termination Bracket has been designed to allow the Protective Earth (PE) wires to be
connected in two ways.
a)
Connection for two PE wires less than 10mm² Cu by using two M4 screws. Maximum tightening
torque is 1.5Nm
b)
A single PE wire if the conductor size is greater than 10mm² Cu by using a single M6 screw.
Maximum tightening torque is 3Nm.
Armature Cable
Assembly
Exposed Braid
Armature Cable
Earth Wire
Two Protective
Earth Wires to
the Cabinet Earth
Bar
Termination
Bracket
EMC Saddle
Clamp
Figure 6-17 Armature Cable Shield Connection with 2 x PE wires
Summary of Contents for AMD2000 Series
