MADE IN USA
SIX YEAR WARRANTY
CouncilMAN Conference System Owners Manual
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com
2
BASIC SYSTEM OPERATION
1. Place a microphone into each base
2. Daisy-chain all the microphone bases and the
AN-100CM+ powered speaker. The speaker must be
near a power outlet – plug in the AC cord.
3. Set the AN-100CM+ power switch to ON and volume
knob to 12 o’clock
4. Push the microphone base MIC ON/OFF buttons once
to talk, press again to turn off. When a microphone is
live, its talk switch will be illuminated.
5. Adjust the microphone so it is near the mouth
6. Set volume controls on each base
IMPORTANT: When the conference system is powered up, all
microphones wake up in the OFF condition.
WhAT IS COUNCIlMAN?
CouncilMAN is a wired conference system that’s simple to set up and
easy to use. The main system components include:
• CHM-100 Chairman base
• DEL-100 Delegate bases
• Gooseneck microphones
• AN-100CM+ speaker/power console
Station to station connection is made using standard microphone
cable with 3-pin XLR connectors. The AN-100CM+ provides power
to each microphone base. Up to 16 microphone bases can be used
with the AN-100CM+.
Delegate 1
Delegate 2
Chairman
Delegate 3
AN-100CM
A typical four base conference system is illustrated here
AN-100CM+ Powered Speaker
The AN-100CM+ can power up
to ten chairman and delegate
microphones. The AN-100CM+
can be connected to either end of
the daisy chain. When connected
at an end, only one of the AN-
100CM+’s XLR connectors will be
occupied.
The AN-100CM+ also includes a 3.5mm standard Line In allowing audio
from other sources to be played through the system. A ¼” Line Out is
provided for connection to a recorder or other device. The power switch,
volume control knob and all input and output connectors are on the control
panel on the rear of the speaker. The balanced XLR Line Out can be used
to connect another Anchor system for larger crowd coverage or to the house
system.
ChM-100 and DEl-100 Microphone Bases
The microphone bases have a 3-pin XLR Input Jack and a 3-pin
XLR Output Jack. Daisy chain the microphones in any order with
the AN-100CM+ using the EX-4M (4 foot mic cable) or EX-25M
(25 foot mic cable). Each base has a 3-pin XLR Female electret
microphone jack
ChM-100 Chairman Controls:
MIC ON/OFF
– push once to Talk and push again to mute, LED lit
when mic is live
Rotary Volume
– adjustable volume for each user’s voice level
Mute Others
– press for several seconds to Mute All delegates in
the conference system or the wireless module
DEl-100 Delegate Controls:
MIC ON/OFF
– push once to Talk and push again to mute, LED lit
when mic is live. If the Chairman mutes all, the Talk/On/Off button
must be pressed to have the mic go live.
Rotary Volume
– adjustable volume for each user’s voice level
OPERATING ThE WIRElESS MICROPhONE
WITh AN-
ChANNEl SElECTION - hANDhElD TRANSMITTER
1. Unscrew battery cover on bottom of microphone
2. Set the CHANNEL SELECTOR dial to match
the channel setting of your receiver on
the AN-
3. Replace the battery cover
4. Adjust volume on AN- and begin
speaking
