Anchor Navi-Trac LT/CS, Installation Instructions Manual

8

Step 3 - Raising the Beam Arches

• Raise 

fi rst beam.  Tie off securely or hold up using adequate installation personnel.  Note:  There are no stakes or guys 

included with this frame, however, the installation kit (sold separately) includes eye bolt and eye nut for attaching to frame 
along with safety webs that may be used to stake or tie-off frame to stabilize the fi rst beam while frame is being assem-
bled.  See Figure 3a.

• 

Raise the second beam arch, keeping base plate in place by using installation personnel or stakes (not included).

Note:  Before Raising Beam Arches, all eye nuts and “X” Cables must be in place as 
shown in Figure 3a.  Turnbuckles should be open all the way.

Figure 3a

First beam arch as-
sembled and raised.

Note:  Turnbuckles 
at free end.

Eyenuts on 
inside of Rafter

Eyenuts face 
ground on sec-
ond rafter.

Eyenuts on 
inside of Rafter

22’ Projection Frame Shown

Frame sizes under 16’ 
projection have only (2) 
cables per bay and no 
purlins.

Note: 

 If you are installing a 2-bay pavilion, both 

bays must be “X” cabled, therefore, eye nuts and 
eye bolts must be used at center beam arch (similar 
to confi guration at right).

1/2” x 3 1/4” cap screw  
and eye nut may be used 
with safety web guys from 
installation kit for stabilizing 
fi rst raised beam.  (instal-
lation kit is an optional 
purchase)

Eyebolt and safety 
webs from installation 
kit may be temporarily 
installed for stabiliz-
ing fi rst raised beam.  
(Use eyebolt with 
eyenut from standard 
frame hardware.)

Eyenut