9
Before placing frame in fi nal position, attach
frame attaching bracket to upright rear upper
splice on each rear upright.
•
Remove stablizer plate, washer and hex nut from rod
on bracket.
•
Insert rod into upright rear upper splice from back of
pavilion.
•
Place stabilizer plate, washer and hex nut back onto
rod so that bracket stays in place. Do not tighten until
frame and fabric are completely assembled and in-
stalled. Do not use stabilizer plate at corner uprights.
Stablizer plate, washer
and hex nut
Plate for connection to
existing structure.
U-Shaped stabilizer may not
be used at corner uprights
due to fabric interference.
Stablizer plate may not
be used at corner up-
rights. Remove.
Figure 3b
Figure 3c
Summary of Contents for Navi-Trac LT/CS
Page 15: ...15 Notes...
