19
11. Display Hold Function
This function holds and displays the weighed value when the it is in the set condition.
HOLD
lights up while the display is held.
Display Hold Condition
The weighed value is held and displayed when it becomes stable at 5d or more, or when the
weighing value is 5d or more and fluctuates within the "Display hold width" for 2 seconds.
Cancel display hold condition
When the weighed value fluctuates from the value being held on the display by 10 times the
"Display hold width" or becomes smaller than 5d, the display hold state is canceled when the
"Hold release time" elapses.
□
The "d" represents the minimum display.
□
The "Display hold width” can be selected by the item
Hold
in "
□
The “Hold release time” can be selected by the item
Hd-t
in "
12.
Impact Shock Detection Function (ISD)
The FG-CWP series has a function to detect impact to the mass sensor section and to display
the impact level. By lowering the impact level at the time of loading, it is possible not only to
alleviate variation in the weighed value but also to reduce the risk of failure of the mass sensor
section.
Impact level display is from level 0 to level 3, 4 level.
Impact level
Shock indicator
Contents
0
No
Safe
1
Caution
：
Consider impact mitigation.
2
Warning
：
Do not apply greater impact.
3
Danger
：
Sensor may be damaged.
Refer to "
" and set the internal setting to
i5d 1
to turn on the function of
displaying the shock level.
□
There is no buzzer sound or memory function upon detection.
Note
□
Impact on the weighing sensor may be applied to the weighing pan at time of loading, or it may
be applied from the floor on which the scale is installed. The impact detection function also
works for impact applied from the floor.
