44
Data Output Mode (
prt
)
Command mode
The scale is controlled by commands that come from an external device such as a personal
computer. See “Command Mode” for details.
Stream mode (
prt1 0
)
Data is sent continuously. The data update rate is approximately 10 times per second, the same
as the display refresh rate.
There will be no output during the setting procedures.
Print key mode (
prt1 4
)
When the weight display is stable, data is sent by pressing the PRINT key.
At this time, the display flashes once to indicate that the data is sent.
Auto-print mode + data (
prt1 5
)
When the weight display is stable at +5d (d = readability(scale interval or "division")) and above,
the data is sent.
The next transmission can not occur until after the weight display falls to +4d or below.
Auto-print mode +/- data (
prt1 6
)
When the weight display is stable at ±5d (d = readability(scale interval or "division")) and above
+5d or below -5d,
the data is sent. The next transmission can not occur until after the weight display falls between
–4d and +4d.
Auto-print mode + data and OK (
prt1 7
)
When the weight display is stable and OK as a comparison result at +5d (d = readability(scale
interval or "division")) and above, the data is sent. The next transmission can not occur until after
the weight display falls +4d or below.
Auto-print mode +/- data and OK (
prt1 8
)
When the weight display is stable and OK as a comparison result at ±5d (d = readability(scale
interval or "division")) and above +5d or below -5d, the data is sent. The next transmission can
not occur until after
the weight display falls between –4d and +4d
.
Baud Rate (
bp5
)
When using HVW-03CWP, select the baud rate according to the device to be connected.
2400 bps (
bp51 0
)
Select 2400 bps to connect to an AD-8121B printer.
4800 bps (
bp51 1
)
9600 bps (
bp51 2
)
